Prevention Of Safety Hazards For Wall Switches
Leave a message
When the house is decorated, there are dozens of wall switches and sockets to be used, and the inferior wall switches will not take long to appear ignition, bringing safety hazards to our lives.
The preventive measures for switch and socket fire mainly include the following eight aspects:
1. Correct selection, that is, according to the total capacity of household appliances and the specific use environment, select the appropriate switch and socket. Places with high humidity should use fire switches and cable switches; Switches and sockets cannot be installed in indoor areas with corrosive substances or dust, but should be installed outdoors; Places with combustion and explosion hazards should use fireproof or explosion-proof switches and sockets;
2. The gate knife switch should use a matching fuse. It is not allowed to change arbitrarily, especially the thickened melt, and it is not allowed to replace the fuse with copper, aluminum, iron and other metal wires;
3. The rated current and rated voltage of the switch and socket should be consistent with the actual electricity consumption. Do not overload arbitrarily, so as not to overload the line and burn the bakelite and cause short circuit and cause fire;

4. The unipolar switch should control the fire (phase) line and cannot be connected to the zero line. Otherwise, if the human body touches the stacked wire, it will also cause electric shock accidents. Once the live wire is grounded, a short circuit will also occur and even cause a fire;
5. The lamp head socket is very prone to accidents when overloaded. Therefore, high-power electrical appliances such as electric irons, electric stoves, and air conditioners should not be connected to the lamp socket to avoid causing fire;
6. When going out, sleeping or suddenly losing power, cut off the power supply in time, especially electric heating appliances should pay more attention;
7. Switches and sockets should be installed in a dry, clean and dust-free position as much as possible to avoid fire caused by short circuit breakdown of bakelite caused by moisture corrosion;
8. After the switch and socket are aged and damaged, they should be repaired and replaced in time.







